The head, seat, screen, drain, and threshold together determine how far shower water can travel across a hotel bathroom. Give water a route to the drain and preserve dry space where someone approaches the bathroom and transfers. Check the build-up below the bathroom floor early. An existing slab, beam, or stack can determine where the drain fits and how far a step-free floor can extend.
Draw where the water is collected
The US Access Board’s guide to bathing rooms discusses accessible shower transitions. It explains where a flush transition and trench drain can be useful and discusses slopes where an accessible surface is involved. Use the guide with the applicable governing standards and adopted local code. A drain at the threshold can intercept water as it moves toward the dry area. The shower floor still needs a continuous drainage path, including around the seat and the plate under the controls. US Access Board, Guide to the ADA Accessibility Standards, Chapter 6: Bathing Rooms
At The LaLiT London, Schluter’s project account documents the use of different outlet orientations for linear drains within floor-level wet rooms inserted in a former school. EPR Architects and Archer Humphryes are identified in the design record. The supplier records both outlet forms. For another existing building, the detail to draw is the relation between that outlet and the structure and services below it. On a refurbishment plan, select the drain after surveying the existing frame and locating the nearest receiving pipe. Draw the trap, waterproofing, and ceiling below before approving the floor setting out. Schluter Systems, LaLiT London, Hotel and Leisure project references EPR Architects, LaLit London
Inspect the membrane and the finished room separately
A manufacturer’s water testing instructions for a shower system describe checking the installed waterproofing before covering it. Confirm the project’s governing test and the party responsible under the adopted plumbing code or specification. The purpose at this stage is to establish whether the waterproof assembly holds water where intended. Record the test before the equipment and finishes conceal the joints. Schluter Systems, Shower System Installation Handbook City of Richmond, Virginia, Shower Liner Test Certification, 2024
Once fixtures and floors are installed, run a separate operating check. Direct the handheld shower toward the positions where someone sitting would use it. Open the screen the way someone would exit, then look at the route to the towel and bathroom door. Use the HSE’s explanation of slip risks from wet surfaces as a reason to include the dry route and the floor cleaning method in the review. The surface may be selected to work when wet, while the location and spread of water can still change how people use the room. UK Health and Safety Executive, Slips and Trips: Cleaning
A section can show where water goes if it gets past the shower screen. A towel on the floor or a change in the position of the shower chair can change where the water goes. Show how the dry approach stays usable when someone leaves with the screen open, and where staff can see splash after a cleaning cycle. If an altered floor cannot accept the proposed drain depth, review the outlet direction, floor build-up, location of the stack, and room position before a change to the threshold is approved.
The drain cover should come off in a way housekeeping staff can manage when the drain needs cleaning. Agree a realistic condition for routine testing, with normal water pressure, the supplied shower head, and any bath mat that comes with the room. Give staff a point at which to report slow drainage or splash beyond the intended area so the building team can tell which condition changed.