GOLEMArchitecture·Art·Design

07.f.3How should a hotel plan bedside space for mobility equipment and charging?

A guest using mobility equipment needs space beside the bed to transfer and another place to leave the equipment while they are in bed. A power outlet should be within reach of that spot, with the cable clear of the route to the bathroom. Guests and access advisers can explain how different devices move and charge, and what bed height and clearance they need.

Draw the bed with its frame and mattress

In the US 2010 ADA Standards, §806.2.3 calls for parallel clear floor space on both sides of a bed in at least one sleeping area of covered mobility-accessible transient lodging, with an exception for a compliant shared space between two beds. In Maryland, §15-208 sets a height of 20 to 23 inches including the compressed mattress and at least seven inches of clearance for a bed lift in covered accessible rooms. Treat these as jurisdiction-specific provisions. Draw the mattress surface and compare requirements with the bed model and loaded, installed dimensions the operator will maintain. U.S. Access Board, 2010 ADA Standards, §806.2.3 Maryland General Assembly, Bed Height in Accessible Lodging Rooms, §15-208 Maryland General Assembly, Lodging Establishment, §15-201

Maria Luisa Toro and colleagues studied transfers by wheeled mobility device users to an adjustable platform. In the experiment, obstacles and available handholds affected what people could do. Show the projection of a fixed nightstand and the end of the bed frame on the drawing so a guest can test both conditions. The project can run trials with guests who use different transfer techniques, including a person who prefers to approach from the other side. Identify which equipment is compatible with the bed and whether the room can serve guests who travel with a companion or attendant. Maria Luisa Toro, Alicia M. Koontz and Rory A. Cooper, Wheelchair transfer setup, 2013

At the former Hotel Brooklyn in Manchester, now voco Manchester, Motionspot’s project account records two suites with a recessed ceiling hoist track and equipment storage in the wardrobe. The operator says the ceiling track ends before the bathroom. The guest transfers into a mobile shower chair to travel onward. That is one coordinated room type. Where the hotel proposes a hoist, review its end positions and the space needed to change equipment, and state which bathrooms or fixtures it reaches in the booking information. Motionspot, Hotel Voco, Manchester voco Manchester, Accessible Rooms

Decide what can stay connected overnight

Power-chair chargers vary by device. Permobil’s guide for its equipment specifies a wall outlet and advises against a timer-controlled outlet. Ask the hotel to identify a position with usable power where a charger and its lead can sit without narrowing the transfer approach. The operator should be able to describe the outlet and circuit to the guest before arrival. Confirm any equipment the hotel lends and who checks it. A fixture controlled by the general room switch may need different wiring if the guest expects uninterrupted charging. Permobil, Power Wheelchair Battery Charging Guide

A guest needs to be able to find their parked device with the main light off, and housekeeping needs to know how to keep that place clear. A piece of furniture against the wall may make a usable docking spot too far from the pillow. Test the proposed outlet and chair position with the guest’s likely route into bed. In a room with a hoist, include the position of the mobile chair during the transfer and the space a second person needs while the equipment is in use.

With the proposed bed base, an open suitcase, and a parked device in place, guests and staff can see how much of the room they can move through. Test how a person reaches the transfer side and the charging point, then test the trip from the bed to the bathroom after the room lights have been turned off. Record the clear spaces the furniture supplier needs to maintain if the bed base or headboard is replaced.