Someone getting up at night should be able to see where to go from the bed, with low, shielded light along the route to the bathroom. Put illumination where there is a change of direction, a door edge, or an object to step around. Check the light from the pillow of the other sleeper. A guest who wants brighter light needs a reachable control for that setting.
Put the light on the route
A laboratory study by Mariana Figueiro and colleagues examined gait in older adults under different combinations of lighting and visual cues. Overall, participants walked best with general overhead lighting and worst with a nightlight alone. Added visual cues improved some gait measures for older adults at higher risk of falling. A problem for a hotel is that each guest encounters an unfamiliar route. Use the study to select cues to try at full scale. A low light that shows the position of a door and the floor on both sides can be more informative than a bright source high on the wall. Mariana G. Figueiro et al., Lighting, perceptual cues and gait, 2011
Lu and colleagues combined interviews with waking trials in simulated darkness in older adults’ homes. They documented a short bed-to-bathroom layout in which light spilled toward the pillow and a sensor that could react to movement in the bed. A hotel can test sensor placement against both motions. Check the range while a person turns over in bed, gets up from the far side, and pauses to open a door. Include the turn back toward the bed with the door still open. Xiaojie Lu, Yue Luo and Boyi Hu, Nighttime trips to the bathroom, 2022
Give guests separate control of light and darkness
The CIE’s 2024 position statement on integrative lighting discusses patterns of light and darkness across the day. It provides reasons to pay attention to the timing and exposure, with a need to design the light for a particular room. Agree whether the cue should run continuously at a low level, be triggered by movement, or be activated by the guest. In each arrangement give the guest a way to find the main control and a way to choose darkness where circumstances allow. CIE, Proper Light at the Proper Time, third edition, 2024
Erik Page and Michael Siminovitch documented a hotel nightlight installation in Redondo Beach in a 2000 conference paper. The trial fixtures had a selectable night mode at 10 percent light output, with a separate occupancy timeout. A hotel considering a new system can include the lamp, driver, switch, and room operating sequence in the same review. Inspect how much light leaks through the gap under the bathroom door and where the fitting reflects in a mirror. Ask the installer to aim and shield the final device before accepting it. Erik Page and Michael Siminovitch, Hotel Guestroom Lighting Energy, 2000
A drawing can show which light a guest sees first from bed and which one they see just inside the bathroom. A bright fitting behind a partly open door can erase the advantage of the lower light in the room, especially when it reflects back from a mirror. Check the walking surface, the sightline to the source, and the light reaching the pillow separately. Give the installer the sensor’s intended limits and record which control gives a guest enough light to see a dropped object or deal with an urgent problem.
Zimmerman and colleagues’ assisted-living feasibility trial tested a visual cue near the bathroom door. The result did not establish a statistically significant reduction in falls, and the setting differs from a hotel. Commission a nighttime trial for orientation and comfort, with the ordinary room furnishings, a case open, and the bathroom closed at first. Record which edges users can locate without help, what a person lying at the other pillow can see, and what happens when the cue attempts to switch off before someone comes back. Sheryl Zimmerman et al., Nighttime lighting feasibility trial, 2024