GOLEMArchitecture·Art·Design

06.f.4How can restaurant furniture accommodate shared dishes and different serving traditions?

People sharing a dish need to be able to reach it while leaving enough room to eat at their own places. Draw the dish at its full size, including its handles and the space a person needs to lift or turn it. If the centre of a table is too far away, use a turning surface, repeat the dishes in smaller vessels or add a sideboard for staff to serve from. Which option fits depends on how the operator wants the meal to unfold.

Put the dish in motion

Daniel A. Gross's account for Smithsonian Magazine traces an adaptation of a revolving tabletop in mid-century San Francisco, associated with Johnny Kan's Cantonese restaurant and George Hall. The turning surface brings dishes to different positions around the perimeter. A design has to reserve the swept area, including anything that sticks out of the dish. People still need a stationary ledge where drinks and individual plates can stay while the centre moves. Try putting a hot vessel down at the point where the server reaches it. Try the turn with one heavy vessel off centre, a partially full bowl of liquid near the rim and the other setting in use. A guest should be able to start and stop the top without the contents sweeping over the stationary place setting. Daniel A. Gross, Smithsonian Magazine, History of the Lazy Susan, 2014

Kaitlin Woolley and Ayelet Fishbach's experiments compared pairs eating shared and separate snacks, and measured later cooperation in tasks such as a simulated wage negotiation. The researchers also observed simultaneous eating in a filmed snack task. The results concern those tasks and participants. The useful design question is whether two people can manage the physical act together. A guest should be able to take food while someone opposite reaches for a drink, and staff should be able to replace a dish without reaching across both of them. Woolley and Fishbach, Shared Plates, Shared Minds, Psychological Science, 2019

The furniture beside the table

Marianne Gray's research into English dining from about 1750 to 1900 describes changes to service in which dishes could arrive successively from a sideboard or the kitchen. Some versions kept a joint at the table. The source pays attention to how the arrangements changed within individual styles of service. The architectural lesson is that a change to the serving sequence moves furniture and work around the room. A sideboard can hold the vessels a server needs close to a table. It needs a surface deep enough to set a plate down, with a standing position off the continuous route while someone else reaches the table. Marianne Gray, University of Liverpool Thesis on English Dining, 2009, chapter 3

Find the height of the apron below a turning top when deciding how to support the insert. In covered US projects, ADA section 902 sets out the clear floor, knee and toe provisions associated with dining surfaces, together with top height. Those provisions address approach and use of the dining surface. Reaching a serving vessel further into the table is a separate physical task. The upper layer can increase the depth of the apron or need reinforcement where people expect to put their knees. In a mock-up, assess the gap under the assembly with diners seated before trying to reduce the distance to the centre. US Access Board, ADA Standards, section 902

A table can be served at two scales during the same meal. A large vessel can be brought to a visible edge for presentation, then portioned on a nearby surface so guests reach individual dishes. Smaller vessels can stay at the table for guests who want to offer a second portion or make their own choice. The furniture that supports that sequence should allow someone to move portions from the landing place without reaching under an arm or across an occupied chair. It is worth drawing the return of the used vessels too. The edge that fits a large dish when it arrives can become a difficult place to recover it while neighbouring diners are still eating.

The table needs to work at the moment when it has to hold the most things. Include bowls that are partly eaten, an empty dish ready for collection and the utensils people are using to serve. Ask the person bringing the next course where they would put it. If they have to lift someone else's glass to make room, give the next dish a landing surface or change the size or timing of the vessels the kitchen sends.